OWC also offers a replacement drive sled (opens in new tab) that does the job, if you're using a 2009-era or later Mac Pro. Mounting a 2.5-inch SSD into a 3.5-inch hard drive sled isn't tricky - you just need a simple drive adapter (opens in new tab) to get the job done. SATA SSDs are, by and large, designed with a 2.5-inch hard drive in mind, because that's what's used in most laptops - and laptops are very popular. The screws match up with mounting holes that are already pre-drilled onto all 3.5-inch hard disk mechanisms. But you don't need your own screws - they're built into the sled. The screwdriver is used to actually mate the drive to the tray to hold it in place. The only tool you'll need is a Philips head screwdriver. To get inside your Mac Pro, you just lift a lever on the back of the box, then slide out the side panel. The internal drive bays are one of those features that's remained a constant through the Mac Pro's evolution, so regardless of which model of Mac Pro you use, it's going to be pretty similar.Īpple's made it very easy to get access to those drive bays, and to put in (and remove) drives. The various Mac Pros that have come out over the years differ in speed, interfaces and basic construction, but they all share common features. It's quick, it's easy and it's trademark Apple elegant, even within the brutalist architecture of the Mac Pro. What makes the SATA bays particularly easy to work with is the Mac Pro's "sled" design - each drive mechanism is mounted on a tray that easily slides out and slides back in, locking the drive into place without needing to manually connect any ribbon cables. SATA is also used to connect the internal optical drive (or drives) your Mac Pro comes with. Inside your Mac Pro are four SATA bays, each of which can accommodate a 3.5-inch hard disk drive.
#MAC PRO 2007 SERIAL#
Serial ATA, or SATA, is the backbone of the aluminum Mac Pro's local data storage interface.